I`m looking for someone who has the mbrp #bb0002 bed stack piping cover. I got mine today , but it doesn`t have any hardware or instuctions . i was hopping someone who does has one could let me kno how you installed it!! Thanks!!

 

Yup, I ran into the same problem. What I did was set it up where I wanted it, drilled holes in the vertical part that will sit against the front of the bed and used some stainless steel rivets to hold it in place. I tried aluminum first (instead of steel because I didn't want rust), but after a while the rivets broke. Using stainless, I haven't had an issue yet.

 

Thanks! Good ideal!! I guess mbrp must just ship them out that way, I`m going to call them next week and ask them about it.I think the rivets and maybe som really goo double sided tape maybe? thanks again for your reply!! I don`t post up much on this site , mainly because it seems really dead most of the time .

 

No problem! I thought of double-sided tape, but decided against it. I have a line-x liner, so I wasn't so sure that it would stick very well. I also though that having the rivets would make it so that if I needed to get in there for whatever reason, I could just drill the rivets out. Yeah, unfortunately, this site doesn't get the traffic it once did.