Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   6.9L & 7.3L Performance (https://www.dieselbombers.com/6-9l-7-3l-performance/)
-   -   digital odometer and sppedometer stopped working (https://www.dieselbombers.com/6-9l-7-3l-performance/87243-digital-odometer-sppedometer-stopped-working.html)

93 7.3L RIG WELDER 12-04-2011 03:57 PM

digital odometer and sppedometer stopped working
 
Hey guys and girls i dont know a ton about this truck its a 1993 f 350 7.3 l turbo . I have a few problems i need help with, my digital odometer stopped working and my speedometer stopped working, also the cruise control stopped. i was thinking fuses i checked them all under the dash and on the fender wall. any other ideas??:dang:

306_schmitt 12-04-2011 04:55 PM

check underneath for broken wires or faulty speed sensor on the rear diff

---AutoMerged DoublePost---

the speed sensor will affect all those things

93 7.3L RIG WELDER 12-04-2011 06:47 PM

The wires looked good will the speed sensor affect the speedometer and the digital odometer.

---AutoMerged DoublePost---

i replaced the speed sensor it did not work for the speedometer or the odometer , they said there was one on the transmission to so i guess i can do that one next.

rjjp 12-04-2011 09:58 PM

Assuming you have an auto, don't drive it until it's fixed, the signal goes from the VSS to the PSOM (speedo) then to the computer, and the cruise. The PSOM could be fubar, got any salvage yards near you?

BW42 05-13-2022 02:28 PM

The speedo gets a signal from the vehicle speed sensor on the '93 -- this signal goes thru the RABS (anti-lock brake system), to the speedo, and then to the E4OD transmission controller. I fixed mine because someone on the weekly Diesel Bombers, speedo thread, mentioned that he had no dome light in the cab. Dome light is connected to the speedo circuit fuse -- fixed that with a fuse in the #8 fuse box position. This fuse also controls the speedo memory, and if it has no power, will immediately signal the tranny controller to go into limp mode. The tranny will revert to limp mode as long as there is no 12v on that line. With my truck being also a '93 IDI, electrical problems crop up for no reason except age. The forum guy who mentioned this said that his fuse showed good, but the connection inside the fuse separated, and the fuse tested out bad. Not sure what happened to mine, but it works now, and the fuse stays good, at least until the next time -- BW


All times are GMT -5. The time now is 08:51 PM.


© 2024 MH Sub I, LLC dba Internet Brands