Which seat will fit if any
 

:humm:Is there any other seats that's just a bolt in my 1st gen:humm:. I seen a 1st gen i parked next to at the store, and it had the 2nd gen seats, and they didn't look as if they fit right. I didn't see the dude, nor did I look directly in it, but it just looked as if there was too much seat. What do I know. All I know is I want a new seat damit!:numb:

Thanks
Billy D

https://www.dieselbombers.com/1st-ge...t-gen-fit.html check this out and see if this will give you any ideas :humm:

X2 I am curious as well.

bolt in... Well you *might* swap in a set of captin chairs from a later model 1st gen. Other then that anything will need mounts made up. Not crazy hard to do.

I would say, was it me you saw? but i'm a bit to far north to be at a store near you.

I have a second gen bench in mine and it cuts into the extended cab a bit much for my liking, but since i'm short i mounted em a bit forward from stock so the rear seat has some room still. for a single cab they should work just fine, but you will need to make up some quick spacer mounts and drill a hole or 4 :tu:

I'm tempted to go dig out some leather chevy seats from somewhere and use those. comfy!

I had 2nd gen seats in my 1st gen and they fit pretty good I thought. I had to drill some holes and make some mounts so they would sit up right but nothing hard.