QC SB Air Dog mounting
 

ok guys i just ordered my Air Dog II 165 (thanks Luke) and Im going to pull my bed for the install but I have read that you cannot mount them on the inside of the frame rail, and after looking at the tight space between the transfer case and the fuel tank i can understand that, but im not sure if i really wanna mount it on the outside or is that my only choice? thanks guys!

I mounted my FASS on the outside of the rail, and the bracket is mounted to the bottom of the bed. I did this to get it up and inside as far as possible.

hhhmmmmm that sounds like a good idea. any chance you can post up some pictures of that? I know ill be driving over some hairy situations and i wanna get it up and out of the way as well.

https://www.dieselbombers.com/24-val...it-bullet.html

There are a few pictures. Let me know if you would like more, I'll lay under the truck tomorrow. The filters on my FASS, which are larger than the AirDog's, only hang down past the body by about 1/2" to 3/4"

thanks man! :jump: this should help! By the picutes it looks like you mounted it before the filler neck correct? and would it be possible to get a pic or two of it on the the truck. thanks again for your help!:rocking:

It is ahead of the filler neck. Pretty much the very front most corner of the box. I'll snap a few more tomorrow.

Thanks your input and advice is greatly apreciated:jump::rocking:

AD II should be here today :jump: so after studying all week Sunday I should be tackling this project and hopefully ill have pics to come! thanks again Luke