edge drag comp and 65 hp injectors?
 

I was wondering if 65 hp injectors and a drag comp would make good power? right now i just have 65 hp injectors and im now looking for a drag comp and i was wondering if it would make good power? Thank You.

what elese do you have done to the truck you need to fill out your sig the guys on here can help you better if they new everything about your truck.

but yes i think that it would make good power but you must have gauges and lift pump and possible trans work valve boddy and torq converter work done at least

well my truck is a five sped with a good non stock clutch. and i have fass ddrp pump. and yes i have fuel pressure boost egt gauges from glowshift.

i think the ddrp might be a little small for that setup but not sure what the output is. the raptor 150 is a good cheaper pump. i got the ard. with the rv275 and they suck the fuel presser down a little bit.

yea the ddrp is a lil small for that set up but i love my raptor 150 its great and good prices to

at idle 20 psi then highway 16 psi and then at wot 11 psi.

but put that extra power comp edge on with the 65 injectoers and you will go in to the danger zone under 8 psi. raptor 150 it would be more safer than the ddrp, can gripe or brag never run one but heard it was more for stock to mild.

do you have to drop the tank on the raptor 150s?

Only if you wish to install a draw tube. We use FASS here and on the 150gph units we recommend a draw tube. the 95gph units get enough flow through the stock pick up.

i heard the new raptor 150s you dont have to drop the tank?