does anybody know the deminsions for oringing the head?
and do you just use a stock headgasket? my local shop will do it, but he needs deminsions for doing it, and he said they can either use a .41 or a .51 wire? i dont know what it means. but any help would be great |
I thought you used a copper gasket but I'm not sure.
|
Originally Posted by dan33klein
(Post 542819)
does anybody know the deminsions for oringing the head?
and do you just use a stock headgasket? my local shop will do it, but he needs deminsions for doing it, and he said they can either use a .41 or a .51 wire? i dont know what it means. but any help would be great My 24v head had .41 wire, the groove was cut .039 wide and .029 deep, leaving a .012 protrusion. I can't remember the diameter of the groove cut though. |
yeah i called another motor guy, he said he can o ring, just a little busy. i just didnt know what headgasket i should use for the best sealing
|
i thought a stock headgasket was wat ppl use
|
im pry gunna use the stock one. i just didnt know if there was anything out their thats better
|
shied diesel
|
called scheids. they only do firerings
|
you use a stock headgasket with o rings
|
ok thanks, were would be the place to get one
|
All times are GMT -5. The time now is 02:54 PM. |
© 2024 MH Sub I, LLC dba Internet Brands