Air dog install position??
Looking at installing my new air dog, I have an 03 short bed, where the hell do I mount it????? No where really good on the frame it seems anybody have help or pics?
|
Not sure the size but I just did a FASS on my 06 and tucked it drivers side front bed bolt- it's tight but fits! You can see it well looking from rear wheel well forward
|
i did the same bed bolt as coal roller. its behind that mud flap i mad on the right.
http://s1027.photobucket.com/user/jgoodwin1986/media/Mobile%20Uploads/20160801_200201_HDR_zpstppcaca8.jpg.html |
|
You doing a sump w. It?
|
Will be doing the beans diesel sump. Looks like I need to notch out a tab on frame to put where I want. Going to leave my factory fuel return in too I think
|
If you haven't done one before then here's my $0.02- run fuel down as far as possible - after getting pump mounted pull the drive shaft(make sure truck is chalked well)- lower tank by loosening 2 bolts on the drive shaft side of the tank- it will lower enough you do not need to disconnect fuel neck or factory lines- unplug factory sending unit connector by moving red clip to back of truck and then pushing toward drivers side-hook in AD- then just tighten bolts back up and reconnect drive shaft- factory lines can stay going to tank so if you need em later they are there and no need to wrestle getting tank back up. Ratchet wrench is a big time saver on tank bolts- also if using manifold for fuel return from AD make sure you don't cut the vent tube (don't ask how I know it's close:humm:)
Sump is easy - follow instructions- I used gray permatex RTV for torx holding rings in place and haven't had an issue |
All times are GMT -5. The time now is 08:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands