DIY 80% turbo whistle increased (continued) Bumper Ram Air
14 Attachment(s)
Thought id post some pics up of my most recent DIY mod, its the poor mans ram air made from a rubermaid trash can and pvc and with the use of the old intake parts. this is an add from "turbo whistle increased 80% in 15min".
parts- 1-old intake 2'-4" sewer pvc 1-4" hose clamp 1-4" pvc coupler 1-rubbermaid trash can (not sure the model but you can probably tell the size from the pics, its the standard office trash can) tools- -saw for the pvc -razor knife -raw man power Attachment 36562 this is the pvc intake idea i got off the other thread with a cheaper air filter, this is before any mods to the heat sheild Attachment 36563 sorry i didn't get exact measurements but here are the basic cuts, on the next 4 pics you are basically need to cut out all of the red area. the line across the front is a fine slit with the razor knife Attachment 36564 Attachment 36565 this is where it will slide past the old airbox supports, the cuts need to be continued underneath about 2" Attachment 36566 same on these cuts 2" underneath Attachment 36567 sorry for the jump but didnt take too many pics, its not going to be easy getting the can in place, i wanted it as sealed as possible so i did the minimum amount of cutting. i took a small 4" pipe went under the truck and spray painted from the inside the pipe to get a circle for my cut for the 4". i also screwed 2 small set screws in the bottom side of the batters box under the battery for some support Attachment 36568 http://http://i1241.photobucket.com/...tumwithpvc.jpg here is a view from the bottom with a short pipe inserted Attachment 36569 here is where the old parts come into play, measure and cut your pipe to length then use your upper 90 degree boot and fasten it. now take your 6" (i think) plastic pipe from the old intake and put it in place before the pipe goes in for easier installation Attachment 36570 here is what the vent should look like Attachment 36571 in this image i cut an angle in my coupler then cut one side of it so it would work with the hose clamp Attachment 36572 here it is from the top with the intake installed, make a half moon cut where you want the intake to come through. found some old 3/4 plexiglass decided to make a lid out of it, used a old radiator hose for a soft seal by the intake and just drilled and put in some self tapping screws in the sides of the can to secure it Attachment 36573 some more pics Attachment 36574 Attachment 36575 |
All times are GMT -5. The time now is 08:06 PM. |
© 2024 MH Sub I, LLC dba Internet Brands