Priming fuel system
How can I prime the fuel system after changing my fuel filter? I don't have an extra set of hands at the moment. Is there a simple way to do it? Please help
Sent from my dumb phone! |
Bump the starter a few times with everything tight and after a few times start the truck. May run a little rough at first but bring up the rpms for a little and you'll be good.
|
Turn the key on, bump the starter (but not not let the engine start), and let the key rest in the run position. This will run the lift pump for aprox. 25 seconds. If that doesn't get all the air out, crack the return line banjo bolt on the injection pump and do it again until fuel comes out.
|
Where's the return like raw?
Sent from my dumb phone! |
And Wats the size? 3/4?
Sent from my dumb phone! |
|
Can hear pump running but won't turn over
Sent from my dumb phone! |
turn it over until fuel comes out of injection pump or line?
Sent from my dumb phone! |
If you loosen #4 half a turn to 3/4 of a turn, air will come out with the lift pump running. Fuel will follow when the air is out of the system. If you can't get fuel or air from there, try the inlet, #3.
|
Well I tried that and no luck. Fuel was dripping out of IP but couldn't get her to fire
Sent from my dumb phone! |
All times are GMT -5. The time now is 05:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands