2001 dodge 5 to 6 speed!!
2001 dodge 2500 4x4 ...... This truck is currently a 5 speed 4 wheel drive ... To put a 6 speed in does the transfer case need to be changed due to the out put shaft size ??(trans to transfer case):humm:
|
No they are both 29 spline so you will be fine
Sent with a Droid RAZR in one hand and 14,000 volts in the other. |
Ok that being said it shouls be a direct swap after puting a 13 inch clutch (proper size) in the truck ....... Correct??
|
should be just make sure you have the right clutch
|
Be careful what input the 5600 has and u will need to do something about driveshaft length.
|
Originally Posted by welderboy250
(Post 893427)
Be careful what input the 5600 has and u will need to do something about driveshaft length.
Ifs it a quad cab/shortbed Ill have complete driveshafts coming out of a 6 speed truck fairly soon. |
be carfull i have a six speed they have a larger flywheele than the five speeds to handel more torqu you shoul be fine running the smaller fly wheele but that is a diffrence so i thought i would throughin my two cents!
|
as previously mentioned, the tcase should be fine. However, the driveshafts will possibly pose problems. I've had 5 speeds with 241LD tcase that the output shaft for rear DS was too small for the driveshaft.
---AutoMerged DoublePost--- As for clutches, you can get the 12" clutch with the big input shaft splining, and retain your stock flywheel, but I wouldn't recommend it. Go with the 13" one for the 6speed. Don't forget that the starter may require a spacer, as well. |
All times are GMT -5. The time now is 02:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands