got an airdog 150 had nothing but problems
i have a 98.5 24 valve and i put a new vp 44 in it along with an airdog 150 i havnt been able to get a fuel pressure reading yet but the truck will continously hiccup and almost missfire at an idle. i was driving on the interstate running about 70 mph when the truck just fell on its face and i got a dead pedal. it picked back up and i drove it to my house immediatly where it died and would not start even with a cracked injector line or two.i have been having a rough idle for about a week now and i continously drain the filter on the airdog. the pickup tube is about 2 inches off the bottom of the tank. now when i bump the key to get the pump to prime it clicks twice and stops. can anyone help me.:argh:
|
well the pickup tube being 2 inches off the bottom is gonna be a huge problem, not with a full tank but when it gets low...mine is 2 quarters off the bottom of my tank and i mean i put 2 US quarters on the bottom of the tank and then thats how long i cut the pipe to...
will the pump run at all...if almost sounds like the pump isnt running right and maybe something is stuck in it |
I would have to say the pump also. If it clicks, you have power to it but why it doesn't run I'm not sure on that. The airdog has been in a week? And the day of install you had the rough idle right away?
|
give airdog a call
|
i cut the pickup tube last night and the truck is runnin alot better but it still has the hiccup at an idle.there are some occasions where it will run perfect and idle with no problems whatsoever. i almost think it could be a bad injector or two but then again everyone i talk to says the injectors either work or they dont. i also have the expandit 5 inch exhaust i got from luke at diesel dawgs and when i get on it the truck crackles kinda like a 6.0 powerstroke and it wont blacksmoke at all. should i just buy some better injectors and see if it cures the problem or try to clean the stock ones that are in it?:humm:
|
Have you got a Fuel Pressure gauge on your truck?
|
FP reading, and if it doesn't get better with proper FP, then have the injectors pop tested.
|
i'm not too familar with the operation of the VP44 but everyone sems to overlook that he put a new IP in and there's a popping noise under load... have you double checked your timing? low fuel pressure can cause the same symptoms; so everyone else is right on too; just dont ignore the other half of the equation that's all i'm saying :U:
|
FP guage x 3
|
also sounds like the pump isnt too healthy; it'd be the first problem i've heard of these pumps having
|
Originally Posted by tower_ofpower
(Post 403537)
i'm not too familar with the operation of the VP44 but everyone sems to overlook that he put a new IP in and there's a popping noise under load...
It could be a crappy rebuild...how much was the VP-44?, where did you get it? and does it have new electronics? |
gotcha like i said; not too familiar... i knew it was modeled after the VE44 just electronically controlled; wasnt positive HOW electronically controlled it was
---AutoMerged DoublePost--- so thanks for the clarification and keepin me from feedin someone BS |
the vp 44 is one of the smartest pumps on the market it not only controls fuel delivery but metering and timing its very advanced its also very dependent on perfect conditions which is its biggest down fall who rebuilt the pump you NEED a fp gauge and call airdog
|
All times are GMT -5. The time now is 03:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands