Diesel Bombers - 245 hp 01 misfire cylinder new pump new injector good compression

Diesel Bombers (https://www.dieselbombers.com/)

- 24 Valve 2nd Gen Dodge Cummins 98.5-02 (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/)

- - 245 hp 01 misfire cylinder new pump new injector good compression (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/118578-245-hp-01-misfire-cylinder-new-pump-new-injector-good-compression.html)

I got the new pump installed and it works great. But now i am getting codes 0122, 1689, and 0382. No miss at all will be requesting the $160 (they charged more than originally requested) and return the bad pump to them. It sounds great, has a small oil leak but that shouldnt take much thinking to repair. And also are there fake vp44, the new one i got had the bosch symbol engraved all over it and the bad was plain except for the 028 and a couple other numbers? But mainly would you know the cause and cure for the codes? Thanks

---AutoMerged DoublePost---

Forgot to point out i only care for the codes since they wont go away even after erasing and i have to pass CA smog.

---AutoMerged DoublePost---

The truck let them go after about 10 miles of driving and smoke is minimal so just breaking it in. Going to smog tomorrow and should pass. Runs smooth turbo is good and it's ready for the road. So i guess they have a bad bosch 815 or lied about it. Either way its fixed. Thanks for all your help

Ok sweet so 0122 is apps sensor voltage to low its probably because it needs to be adjusted i dought its bad check the sticker on the back and probe the apps and move the throtle to see what volts you have and the 0382 is you grid heater make sure you have your ground put back on the right spot and make sure the fuse is is inserted properly

How do i adjust the apps? And the grid works but i will check. Thanks

You have to back probe it go to.bluechipdiesel.com and look under trouble shooting they have pics and its very easy did you replace the apps as well i cant remeber if you said you did or not

The apps suffer from poor ground and interference issues. If it's showing low voltage you'll likely be looking at something like a Timbo apps.
The grid heater code is referring to the control circuit. No fuses to check, just check the small wires of the grid heater relays. I think that's the code for solenoid #2. Should have voltage while the grids are energized. Likely that the wires just come loose.

Sent from my SCH-I605 using Tapatalk 2

Ok ill check them but the light self cleared so not as worried for smog.