Throttle rod end.
 

Hoping to make it into the sticky :rocking:. I broke on these plastic ball n cup joints a while back n made a temp joint as cummins wanted to much for the kit.

So after about 2 hours n three different parts store companies I found what I was looking for. Now I coulda got any old ball n cup joint n had a new rod made up but I finally found one that fit.

Attachment 38688

Part Number Papco 262-204, Stud 5/16-24", F 0.531", G 0.688", J 0.438", L 0.500", M 1.406", N 1.125", P 0.563".

But I also found it here n this is where I got all the specs on it. ES312: ES - Midwest Control Products Corp.

If I ever have to replace the other end I will get a custom rod made up and another joint the same as what I have now n run both. OH I paid almost 8 dollars for the joint where cummins wants $56 CAD for both ends and the rod. I told em where to put there kit.

Here's a pic of the setup as of now.
Attachment 38689

Here is the joint I had made up front a piece of ready rod n a bolt coupler.
Attachment 38690

nice. you can also buy the recall kit from chrysler. they are cheap

I was told a price from them but they said it was discontinued and there price was higher then cummins. I told both cummins and dodge to go shove it.