help please. widows will not go up
 

hey i tried to put my power windows up tonight, and there was nothing.. i check the fuze it looks good, plz any help will be appreciated.

---AutoMerged DoublePost---

is there anything else that could have blown?

neither window or just one? can you hear the motor doing anything at all? test light at the swich for power then down the line

both windows.. and there is nothing. no motor or nothing.. did some research and also found out that my blower motor isnt working...

fusible link man! one burned up!!! I have had living hell with fusible links!!! rewire all of that. There is a sticky over replacing all the fusible links with maxi fuse's

thanks. is it hard to do? can you get new fusible links? where there located at?

No its not that hard. And Im not sure if can get new ones or not. And they are are located on the drive side, on top of the fender.

---AutoMerged DoublePost---

And no problem man!

Hey man, you can make fusible links easily. Get some wire, wire crimpers, two terminal crimp connectors (which you can fit a maxi fuse on... so big enough), and your maxi fuse. Wham! there you have it. But just grab a multimeter or test light, see if you have power going to the motor if you don't it's probably your wiring. If you do check for ground, if you have a reliable ground, it's your motors. Which is not probable since they both went out at the same time, unless you have bad luck. As well check the listing of all fuses, because sometimes windows or just random accessories can share fuses. [Example: stop light, ignition and windows can share the same fuse] so read through all the fuses.

I replaced 2 of mine with circuit breakers and they work great and u never need to replace fuses.:tu:

If not the fusible link then check the actual switch...its not too terrible to take apart....I've had the same problem with mine and i had to solder the ground pin to make a better connection....has been working good so far