LEAF SPRING BUSHINGS ?
 

I was wondering if anyone knows the best way to take out the bushings in the leaf springs I ordered mine today so I have not took it apart yet but I was told they can be a pain in the a:edit: to change just wanting some ideas?

LEAF SPRING BUSHINGS ?
 

Could heat the spring slightly to open the eye up. Or use a wedge and drive it between the leaf and the eye to relieve some pressure on the bushings collar. It's going to take some solid hits, I removed the ones from my skyjacker springs and replaced them with urethane bushings. They came out hard enough being new so... Good luck


Sent from my iPhone using Tapatalk

BFH....

find someone with a press and youll be all set. well thats if ur taking ur hole leaf spring pack.

you can burn them out with a torch. but watch out the steel sleeve will shoot out when it gets hot enough

ya burn them out and use a air hammer and just push them threw, the i made up a tool big/ long threaded rod welded a nut on one end with big washers and press the new bushing in with that. works well if you have a half inch impact gun.

i did my front ones and they are polyutherane i believe with a steel sleeve that the bolt goes through. Mine were pretty stuck in there i had to drill outt the steel sleeve and work around the bushing and between the spring with a screwdriver to get it loose. It was a pain in the @$$

air hammer works good, just make sure its a good one and it will knock em right out no problem

a buddy of mine says a ball joint press works good i haven't tried myself though.

Get em out yet?