.040 piston pertrusion
 

Will a .020 thicker head gasket take care of the problem ? I had to have .015 taken off the top of the block to clean it up so I now have a pertrusion of .040 ! My new gasket at its thickest point around the metal ring for each piston is .095 thick ! and the gasket material is .055 thick !
My question are the thicker Cummins gaskets have a thicker base material plus a thicker ring? :s::s:

yes the whole gasket is thicker!! I had to take .013 off of my block and took .008 off the head and used a .020 gasket.. compared to stock the whole gasket was .020 thicker. hope that helps ya!:tu:

Thanks
 

Thanks much as I had never had to install a "Thicker" gasket !

be sure to wear your shop glasses