cooooooool air
I picked up an intercooler out of a 05 duramax at a swap meet really cheap...was wondering if there was anyone out there that has put that in a 92 dodge before...hah could use some help..mock up sucks but its slowly going!! anything helps guys!!!
|
I don't think they will fit. Also if I remember right they have plastic ends.
|
i can make it fit...i was just wondering if anyone has done it and can give me any pointers..and this one is all aluminum...i just need to get a big hole saw so i can make a few cuts and then hope it will work with the grill and header panel! its going to be tight!
|
Snap some pics and show us your progress. I am fairly certain no one on DB has tried it that I know of. :tu:
|
will do, kind of confusing right now, i have another radiator support im mocking up on before i get it anywhere near the pickup just to make sure...ill snap some pictures in the morning for sure
---AutoMerged DoublePost--- haha i snapped a couple of pictures this morning but my phone likes to be retarded when i want to use it!!! will work on this and try and have them up by evening |
2 Attachment(s)
|
i couldnt get it to upload the one i doodled on but you see in the second picture there i had to cut the stock intercooler mounts and the center mount for the lower grill piece off, i need to get a spot weld cutter from my buddys shop this after noon and both of the upright stiffeners are going to have to go for the time being, will snap some more pics morrow depending how far along i get tonight
|
Great looking project!!! Got any photos of the candidate truck?? I will be watching this one!!:pca1:
|
A BFH will make it fit! Looks like some engineering is in order. Keep us informed. I, for one, am very interested.:c:
|
2 Attachment(s)
Attachment 25760
Attachment 25761 the pictures may be out of order a bit but it all happened tonight, also there is a pic of the donar truck, 92...nothing special, turned up pump and in the process of putting a getrag 5 speed in.... but i had to cut the radiator support basically to nothing. took the up right supports with the spot weld cutter and then had to cut the bottom horizontal brace to where it was flush with the main piece of sheet metal. |
2 Attachment(s)
Attachment 25762
Attachment 25763 here you can see the bottom horizontal brace cut, its kind of crud in this pic but you get the idea. i dont want anything in my way. also in the other pic, i am going to have to cut all the mounts off of the intercooler and hope things work, (fingers crossed) i ran into an issue looking at the donar truck. i think the A/C condenser is going to have to go behind the intercooler seeing is this intercooler is about 6 inches wider than stock and the stock lines for the A/C condenser are just wide enuf to past the stock intercooler....will keep you posted on that process but anyways, i have more cuts than people need to deal with in one night and morrow hopefully i get some more sawsall blades and another flap disk for the grinder so i can get the intercooler brackets all cut off. |
:pca1: :c:
|
:pca1::pca1::pca1::pca1:
|
well over the last couple of days i got the intercooler bolted in the right location and everything fabed to start welding braces back in...will post pics later on tonight when i get back to the house.
|
Don't mind me.....just waitin for pics. :w2:
|
All times are GMT -5. The time now is 05:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands