how much timing
ok well i got a p pump on now and ill be setting my timing tomorrow.
i got 5x.014 sdx injectors, 131dv's, phat shaft turbo. i only want to time it once i dont want to mess with all the time. in the next 2 weeks its going to get 191 dv's, 4kgsk, 60 lb valve springs. so i want to set the timing to what will work with those settings. i was thinking about 20*. does that sound about right or do i need more or less? |
Do you have studs? it you do 20* is fine.
|
no but i plan on doing them in the very near future
|
20 sounds good as long as you get those studs in
|
damn.. now u guys r makin me want to put mine to 20!
|
17 to 20 anywhere in that region
|
well money got a little tighter today so studs wont be as soon as id like so im probably going to go to 18 and stay there until i do studs
|
16.5* is as high as i would go with out studs.. imo.. but i am not a gambling man!
|
so what is the difference in 16.5* as compared to 20* from the studs standpoint? will give more boost or what makes it worse without studs?
|
the big increase in cylinder pressure will stretch your stock bolts and cause your head gasket to go to crap.:dang:
|
oh got ya. looks like 16.5 it is. for the time being at least:w2:
|
I would never go to any timing above 16-16.5 degrees without studs and an o-ringed head.The increase in cylinder pressure will cause a premature failure of the headgasket.
|
I got 19* on mine and my mileage is crap. MY mileage went from 18.5 to about 15 with upping my timing. I'm going to back it off to about 16.5* or 17* and see what happens
|
How much timing can you go and still start easy in the winter?
|
Mine started fine at 19*. Well If the temp stayed above 8* after that it was a bear.
|
I ran mine at 20 degrees all winter long with no issues at all.They are a bit fussy to start when you run higher timing but can be started.With mine as long as the temps were above 20 all I had to do was the normal start up procedure,below 20 I had to cycle the grids a second time and she would start off.
|
set mine to 16.5 the other day it dont run bad but sure run alot smoother my first good pull on it snaped my inputshaft
|
All times are GMT -5. The time now is 08:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands