Pulling tips
I would like to know some tips to pulling. I have done it in a manual but not automatic. The truck is a 96 12v with 684hp. Big single turbo (s472 .9ar) starts making 10psi at 1800rpm and 60psi at 2200 rpm. 250hp injectors, pump work, cam, built gorerend tranny. I am installing suspension stops this weekend and putting my ladder bars on this after. I would like to pull in D if i can to get some speed. I also have the tps delete so i can choose my shift points. I can make the truck shift at anytime up to 3500rpms. I am thinking D direct buy turn the knob to about 2800 rpm to allow for shifts. Should this be in 4HI or 4LO? or should i do it differently?
|
u go into drive its gonna fall on its face. 4Lo start in first then second and let her eat. pump the brakes and ease into the throttle till you feel the truck and chain stretch, then slowly ease off the brake and into the throttle.
|
need to know gear ratio and tire size ... do you have a converter lock up switch?
|
lock up switch 3.55 gears and 35 tires bout 45% tread
|
u need more gear IMHO .....
|
2nd gear low range with those gears:hellox:
|
I know in second gear at the end of the track my truck will fall of its face with this big charger. I need wheel speed and keep wheel speed
|
Originally Posted by diesel pap
(Post 1021294)
2nd gear low range with those gears:hellox:
Originally Posted by 96cummins12v.
(Post 1021301)
I know in second gear at the end of the track my truck will fall of its face with this big charger. I need wheel speed and keep wheel speed
|
But when the pan hits I'm gonna lose my rpms without maintaining that wheel speed. This turbo doesn't make good boost till 2100rpm so I'm thinking more 4lo Drive, turn my shift points to 2700rpm and before the pan hits unlock the converter
|
4low in 3rd gear is way too big of a gear your not going to be able to turn it with that rear gear and tire size
|
All times are GMT -5. The time now is 06:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands