fp gauge install help
#2
I'd just get a T in the line wherever you want to put it,somewhere out of the way,I did not bother to use a isolator,just make sure the dang thing don't leak cause' it takes forever to get the stink out of your cab....
The line to the FP gauge should be pretty small,I mashed mine a little so the vibration from the VP would not hurt it,though I'm not sure that is strictly necessary.
I just ordered one of these to T in with Glacier Diesel Power - Product Detail
---AutoMerged DoublePost---
But you could use anything like that you wanted,make one up from the hardware store with a Female T and a couple of barbs if you want.
The line to the FP gauge should be pretty small,I mashed mine a little so the vibration from the VP would not hurt it,though I'm not sure that is strictly necessary.
I just ordered one of these to T in with Glacier Diesel Power - Product Detail
---AutoMerged DoublePost---
But you could use anything like that you wanted,make one up from the hardware store with a Female T and a couple of barbs if you want.
Last edited by Mr.Krabs; 12-16-2008 at 04:14 PM. Reason: Automerged Doublepost
#3
there is a plug you remove and take your readings from that port. I ran a line to a snubber and a mechanical gauge and tee to a digital fuel pr. guage Ed
#5
I would have to go under the vehicle and check but I believe I removed
an allen head plug in the aluminum block of the airdog. Let me know if
you find it if not I will go under the truck and check it out. Last
resort I would call Charles the owner of air dog at 573 2308838. let
me know and I will help you out
an allen head plug in the aluminum block of the airdog. Let me know if
you find it if not I will go under the truck and check it out. Last
resort I would call Charles the owner of air dog at 573 2308838. let
me know and I will help you out
#6
I would have to go under the vehicle and check but I believe I removed
an allen head plug in the aluminum block of the airdog. Let me know if
you find it if not I will go under the truck and check it out. Last
resort I would call Charles the owner of air dog at 573 2308838. let
me know and I will help you out
an allen head plug in the aluminum block of the airdog. Let me know if
you find it if not I will go under the truck and check it out. Last
resort I would call Charles the owner of air dog at 573 2308838. let
me know and I will help you out
Biged there is a picture in your install manual,it's where the warning light pressure sender can be installed
Thread
Thread Starter
Forum
Replies
Last Post
scottxmorris
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
10-08-2014 02:14 PM