Oil leak
#1
#2
#3
I wouldn't pay to have it done... but I have access to two shops and three lifts. If I was going to do it on the ground in my driveway -or even on jack stands in my garage for that matter- I'd probably be getting prices. I'm not saying it's a piece of cake, because it isn't, but IMO $800 is a little on the high side.
#5
yes you have to jack up the motor a ways unless you have trans and flywheel housing off, it is possible to get pan to drop down a few inches but its pretty impossible to get the pan and block clean I tried this and it leaked more than before so I ended up doing it twice but I you think u wanna try it be my guest maybe ull have better luck than I did
#6
Thread
Thread Starter
Forum
Replies
Last Post
pro graphic solutions
Diesel In Distress - Support Ticket
1
02-10-2015 03:48 PM