How do they compare to the DDP 95's 8 hole flowing 39 lpm?
Thanks! |
You have a PM Mike
:c: |
So what lpm are the 5x14 injectors. Also what do you do to the injector. Is it only pushing the holes out bigger or do you do internal mods??
|
Beave, you know DDP is the best, what info are you looking for here?
|
Beave you have a pm.
|
Originally Posted by Smokem
(Post 403490)
Beave, you know DDP is the best, what info are you looking for here?
|
Could use some CR injectors maybe smokem needs a test truck in IOWA
|
:U:
|
If that's the case I'll take my truck done there and he can have it till it's done :D
|
Chris and Jamie will most likely handle all CR nozzles, Extrude Hone is used for these applications. As far as the 12v and 24v injectors are concerned, I am finishing up making a few alterations to the nozzle type and pintle design so that manufacturing can proceed. I would like to add a secondary needle guide to the older mechanical style nozzles such as the CR uses. This would prevent uneven seating area wear and low lift needle deviation.
|
All times are GMT -5. The time now is 01:10 PM. |
© 2024 MH Sub I, LLC dba Internet Brands