Why You NEVER Stand Near A Dyno...
 

This ladies and gental men and kids is why you NEVER stand this close to ANYTHING on a dyno. They are lucky nobody was hurt or killed... WOW.... Thats stupid :ph:

Cam 1

Cam 2

Cam 3

RETARDED shop owner to say the least.... Theres lots more vids at that event of people within feet of the rear tires... :ph:

That's pretty scary!!! :nshock:

That was destined to happen, To few straps, Not tight enough, To close to the front of the roller!
A big props to whoever was in the truck ,that could have been alot worse!
If that truck had not been controlled that would have put the shop outa business and then some!

On the up side, You can tell they were loadin that sucker lol

yep that would have hurt

Truck shop I used to work at had a Kenworth go threw a wall. (It happened before I worked there) The dyno was shot and you could see the big section of wall that had to be replaced.

Um oops. I think they need bigger straps:ph:

The same thing when i worked for Mack. They'd blow everything from tires to motors. The theory there was if it survived the dyno then it would survive in the field. :ph:

Holy crap! I love that people were cheering before they were even sure if anybody had been injured. :booo:

The last dyno event I was at, I as most everyone else that was there stood on the other side of the shop or outside.

DANG!!!It's a good thing the guy in the drivers seat knew how to react fast.They should have roped off an area around the the truck to keep people away.Could have been much worse.:ouch:

I want my truck to run like that.....:pca1:

holy fak!

I disagree , to everyone who is stupid enough and wants to lean on the truck while its dynoing , be my guest :D

man..atleast nobody got hurt props to the driver for a good save

Nice truck, but yeah i have to agree that would not have felt good to get hit!

The first time I ran my truck on a dyno a strap broke. The dyno operator used 4 straps on the back, 2 on the front plus wheel chocks in front and behind both front wheels, so even with 1 strap breaking there wasn't much of a chance the truck would move. They always made sure no one was near the truck or anywhere in front of the truck.

Hella good save by the driver. I saw a "redneck race truck" break its driveshaft in half on a dyno and sent it flying 15 ft and hit a guy in the feet. Still don't understand why people think nothing bad will ever happen on a dyno.

No kidding thats alot of HP and Torq to be messin with just a accident waitin to happen that was lucky lucky to say the least phew it could have hurt:s::s:

....and they're hootin' & hollerin' like it's cool.


Idiots are everywhere......

yup all aound the world

lol


Poor guy.....good face plant, though.

:101010:

seriously how dumb can people be:humm:

wow nice face plant. Imagine if he stepped on it when it was under full load...

I was at a local dyno day once and decided the best place to stand was off the back corner of the car, so if it kicked to the side it wouldnt hit me and if anything got spit out the back it wouldnt hit me. Naturally standing in front of one is a horrible idea.

Turns out it was a pretty good plan, on the first pull a Camaro broke a rear ujoint and the shaft dropped to the ground, hit the roller and got shot out the door of the shop. Needle bearings and caps were all over the place!

Hey maybe after they are done at the dyno, They can all run out to the local freeway and see who can make it all the way across!:argh:

I agree poor guy but he needs to watch where he stepping:ouch::ouch::argh: