Diesel Bombers - Search Results

Go Back  Diesel Bombers > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: jrsavoie
Showing results 1 to 25 of 67
Search took 0.03 seconds.
11-16-2017, 11:04 AM
Replies: 39
Views: 145,421

Just checked after fixing exhaust leaks. Getting...

Just checked after fixing exhaust leaks. Getting 19 on secondary roads (not Highway, but in the country 60-65 mph). only real upgrade is 4" Exhaust and upgraded to high flow filter from a 97. That...
11-16-2017, 04:44 AM
Replies: 2
Views: 420
Posted By Anne Flemings

She probably meant, "We specialize in being high...

She probably meant, "We specialize in being high quality scammers.... " blah blah
09-20-2017, 12:16 PM
Replies: 2
Views: 420
Posted By Diesel_Daddy6.0

I got the exact same PM this morning. First red...

I got the exact same PM this morning. First red flag for me was "I'm Ella from a big company." Never going to get people to give their opinion of a product if you won't even state your company. And...
03-29-2017, 04:18 PM
Replies: 8
Views: 584
Posted By EVT1

Have you relocated the pmd? I had the same...

Have you relocated the pmd?
I had the same problem a few years back & it was the terminals in the connector between the IP & the pmd, same situation. No idea what it was, no codes, shutdown hot or...
Forum: Jeep Liberty
02-24-2017, 01:10 PM
Replies: 3
Views: 2,415
Posted By micmed

Similar issue here. I have a 2006 CRD with 150K...

Similar issue here. I have a 2006 CRD with 150K on it. Had a few minor issues at first but solid overall and well maintained. Went to start one day and cranks but no start. Pulled code P2294 FPS....
02-23-2017, 05:58 PM
Replies: 7
Views: 772
Posted By InheritedDiesel

There is flow, then there is adequate flow. If...

There is flow, then there is adequate flow. If the fuel sock is clogged the stream will be weak, which stresses the injection pump, which in turn stresses the FSD. This causes short life spans in...
11-17-2016, 08:36 PM
Replies: 4
Views: 800
Posted By Mayhem

Injectors sound like they are sticking and or...

Injectors sound like they are sticking and or dirty leaking fuel into the cylinders run a can of seafoam in with fresh fuel that should do it if not put a quart of transmission fluid in the tank.
09-28-2016, 11:56 PM
Replies: 6
Views: 862
Posted By petew

I finaly found and fixed the problem. The turbo...

I finaly found and fixed the problem. The turbo sensor on the intake manifold and the solenoid . I just changed both and now I have decent power from stop to highway speed and good pulling power on...
09-22-2016, 11:54 AM
Replies: 12
Views: 916
Posted By EricR

Truck is running again:tu: Thanks for all the...

Truck is running again:tu: Thanks for all the advice.


I knew it was not the ignition, as when it shut off, it had steady power to the pink #439 that feeds the PMD.

Sent the PMD back to SS...
09-22-2016, 09:41 AM
Replies: 12
Views: 916
Posted By InheritedDiesel

If the ignition switch has never been changed...

If the ignition switch has never been changed then that could be the culprit.
09-21-2016, 11:46 PM
Replies: 5
Views: 912
Posted By Cree

6.5 Diamond Eye ... No problem!

Well, after reading all I could, I bought and installed the Diamond Eye kit with no muffler in my 95 Crew Cab dually 4wd. I know that a lot of folks have had some issues with the clamps and the...
09-05-2016, 12:53 PM
Replies: 6
Views: 862
Posted By Edward Black

97 suburban

I am having the same problem with a 97 suburban all stock, but when mine goes into this no power mode, the fuel gauge also jumps around and it will pull hard for a brief second and then back to no...
09-02-2016, 08:51 PM
Replies: 2
Views: 517
Posted By petew

Found some . :jump:

Found some . :jump:
08-24-2016, 09:54 PM
Replies: 7
Views: 710
Posted By birddog596

i guess ill have to bite the bullet and give that...

i guess ill have to bite the bullet and give that a shot thanks for the advice ill do it tomorrow and let you know what happens
08-24-2016, 09:48 PM
Replies: 7
Views: 710
Posted By petew

I had similar issues a while back. It turned out...

I had similar issues a while back. It turned out to be bad grounds. I ran fresh ground wires from the battery to the pump, PMD, and the stud on the engine block .This seend to cure the symptoms you...
08-12-2016, 03:40 AM
Replies: 1
Views: 527
Posted By burnhedge

I think their's a 9.5 14 bolt a 10.5 14 bolt. ...

I think their's a 9.5 14 bolt a 10.5 14 bolt.

Both have 14 bolts on the cover. The cover on the 9.5 is round. The 10.5 is a hexagon ish.

I've never seen a 10.5 in a 1500 just heavy 2500's and...
Forum: Jeep Liberty
06-08-2016, 09:49 AM
Replies: 15
Views: 14,664
Posted By dennhop

I finally got tired of the thermostat issues, the...

I finally got tired of the thermostat issues, the rocker issues, and more and replaced them all with a 2006 Dodge Megacab 2500 CTD. Best mod I ever did to the Liberty CRD. Don't know why I waited...
01-22-2016, 12:52 PM
Replies: 5
Views: 758
Posted By Turbine Doc

Check also the ECT sensor the GP control is...

Check also the ECT sensor the GP control is "dumb" it relies on ECT/PCM to tell it that it is cold out, once you are out of start mode your glow should be out of the loop, next time you see this...
01-18-2016, 05:15 AM
Replies: 5
Views: 758
Posted By cjt8569

Checked grounds ,cleaned battery cables and...

Checked grounds ,cleaned battery cables and replaced the GP module seems to have done it ..165k original GP module think it was time...
12-15-2015, 11:16 PM
Replies: 9
Views: 1,226
Posted By Josh Haynes

First off, This isnt a gm 6.5 caused issue, this...

First off, This isnt a gm 6.5 caused issue, this is your cheap ass letting some back yard mechanic butcher your truck. Please modify your thread title to reflect reality. Look up heath turbo...
11-18-2015, 11:28 AM
Replies: 6
Views: 1,951
Posted By Turbine Doc

To a point it would help, if you run a mech boost...

To a point it would help, if you run a mech boost control on your 6.5 and it being OBD-II all you will do is get more boost for a while, but when the boost does not reduce tike the PCM wants it will...
11-05-2015, 04:11 AM
Replies: 4
Views: 1,488
Posted By Jet A Fuel

X2 Doc's right about the money. You can make any...

X2 Doc's right about the money. You can make any engine perform better by adding mods and engine machine work. But the amount of money you will spend on one engine will go further on another just...
11-03-2015, 12:44 AM
Replies: 11
Views: 3,659
Posted By noserider

Jet Here is a post I found. ...

Jet

Here is a post I found.


This has been covered several times in the 2nd generation engine forum. You can install a relay like I have done like this. Install a relay near...
11-02-2015, 10:27 PM
Replies: 11
Views: 3,659
Posted By Jet A Fuel

That is the craziest thing i have heard in a...

That is the craziest thing i have heard in a while, The ECM is only a control circuit for the opening and closing of the relay. It uses the same volts/amps to operate the relay no mater what pumps...
10-26-2015, 06:16 PM
Replies: 11
Views: 1,306
Posted By Mayhem

Sounds like it was too late then before you put...

Sounds like it was too late then before you put the new converter in, I hope you have some kind of warranty on that rebuild.
Showing results 1 to 25 of 67
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.