2001 24 valve in pieces, injectors, turbo stuff.
 

2001 5.9 24 valve NON-53 longblock (No injectors, no cam, no pump or timing case), all head components are included, lines, supply tubes, rocker arms, pushrods, head bolts, etc., very clean bores and crank, shortblock is still assembled, with the exception of one piston and rod, which I do have, includes a nice pan and pick-up tube. This is a very nice lower miles (@130,000 miles) engine. $1000.

Set of 6 "90 Horse" VP injectors, not sure who built them, they appear to be 8 hole, has the number "62992" scribed on the tip body, very nice and clean, $350.

HE351CW turbo, from an '07 5.9, was pulled off with around 3,000 miles on it, it looks and feels like new, $375[ [PENDING SALE] .

5 inch(?) downpipe from an '06, NO clamp, $80.

Cast downpipe elbow from an '05, fits both items above, $50.

If you want ALL of the above, throw me an offer!
I do travel a lot, so delivery is also possible.

Reply, PM, or call 402-780-5127.

Do you often travel down towards TX? I may be interested in the longblock.

I go anywhere the need arises and if it doesn't cost me too much in fuel.
Been through Wichita Falls a time or 2.

Mark.

INTERESTED IN THE BLOCK... WHATS YOUR LOCATION??

It's in my profile. :s:

Mark.

interested in the oil pan. Do you have any idea if they are any different than a 12 valve pan, mines toast. thanks

I'd prefer to sell it all in one shot, BUT I may have an extra pan coming in.

I believe they are the same through '02.
I was comparing some a few weeks ago and other than the color inside, they appeared the same from '94-'02.

Mark.

Mark, did yoiu sell the 351 turbo?

Yes I did.
I have 2 others here that I'm going to rebuild as soon as I get the kits in to do them.

Mark.

i want the block... if its still got bearings and everything in it still

Bare block, or SHORT block?
Need pistons and rods?
All of the bearings are there.

Mark.

may be a dumb question what year truck are the injectors for:humm:

I think they are for ANY VP44 24 valve.
They have someone's numbers scribed into them, but I have yet to figure out whose, so I can get the true sizing on them.

Mark.

When will you be done with the other two turbos?

It'll be a bit, I still have to order them and money is tight.
I also need to take the one apart to make sure it doesn't need anything, but it appears okay, just loose.

Mark.

i need the block with good bearings and pistons rods.... pretty much need full rotating bottom end

It's still all together like that, with one piston and rod out, but it was only removed to check the condition of the bearings, manufacture location on the rod, and condition of the piston (#5).

Truthfully, I'd really like to just off the whole longblock.

Better yet, I even have most of the parts to do a '98 P7100 215HP conversion. :tu:

Mark.

im intrested in the injectors if you still got them

gimi a call at 1 620 277 8992 very interested

It's all still available.

Mark.

i want the injectors

PM me on how you wish to pay for them.

Mark.

---AutoMerged DoublePost---

Found some P-7100 to 24 valve lines to put this together with a P-pump, so I have decided to hang onto this engine and all the pieces.

Mark.