truck all of a sudden runs like crud... lots of codes pulled
Ok I have an E99 with the XLE4 computer with Tony Wildman tunes on a 6 position TS chip. Been running it for a while now with never any problems. I was driving home from work today, and she started running real rough like it was only running on 7 cylinders and got about 1/4 mile before it wouldn't go over 15mph. So pulled into a parking lot trying to figure out what's going on. If I start the truck it runs real rough and shuts off....
I finally got the truck started and it idled good, and drove it home with no more issues. ok so check this out.... my buddy brought over his SCT tuner to see if i have any codes. this is what we found: P0237 turbo boost "A" circuit low P0713 Trans Temp Circuit high open P1281 ICP Sensor circuit high P1394 Glow plug circuit high P0123 Throttle pedal position high input open P1690 Wastegate solenoid circuit P0500 Vehicle Speed VSS P1670 Electronic Feedback signal not detected P1316 injector driver module not detected P1212 injector control pressure lower than desired (engine crank or run) P0236 Turbo boost"A" circuit range performance P1211 injector control pressure higher/lower than desired (engine running) P0720 output shaft speed sensor circuit then we started it after clearing the codes and it runs like crap again. So what the heck is going on with my truck????? |
If you unplug the ICP sensor, does it change anything?
|
Ok do we figured out why it runs like crap. Helps if you have fuel. On a hunch I went and got fuel and it took 36 gallons of fuel... I was probably picking up garbage, water or was simply aerating... Feel stupid now... Smack up side the head.. In my defense truck was showing between 1/8 and 1/4 tank
|
Lol... Scan the truck in a week or so and see if any of those codes come back...
|
Lol will do bud thanks!
|
All times are GMT -5. The time now is 06:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands