ABS light on?
My ABS light turned on all the sudden. No hard breaking, not towing a trailer nothing, just got in my truck the next week and it was on. Any ideas? when i turn the key on but dont start her and push the breaks all the way to the floor it turns off but about 1-2 seconds after i let off the breaks it turns back on
|
on the front axle, there is a sensor on the hubs. check those. it might have came un plugged. lol
|
:humm: dont see one... everything looked plugged in I those have 3 lines running to each front wheel and there all plugged in... then again im not sure what im looking for and exactly where do i have to take the tire off or turn them to see or...
|
well if they seem tight then it's fine. one is a brake line, vacum line, and a wire for the ABS. under the dash. check the brake switch on the brake pedal. or the plugs on the master cylinder.
|
will do. thanks buddy
|
any time.
|
so i checked my sensor/connector deal by my break pedal my master cylinder is full and all the lines around the wheels are good and it still on... any other ideas?
|
ABS light on?
The ABS light will throw a code. Go have the code checked and it will tell you what the problem is. Last time mine came on, it was the ABS sensor on the rear axle went bad.
|
thanks man
|
jack up the front wheels see if they are loose could be wheel bearings wore out and metal on the sensors
|
All times are GMT -5. The time now is 05:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands