Hi ladys n gents

From down under in sunny Australia

im in the process of undergoing a engine conversion on my 2001 f250

it current runs a mwm 6.07tca 4.2L 6 cyl and zf5 but wanting to convert to cummins power
I have lined up a 2008 dodge ram 2500 with the 5.9 cummins common rail and 6 speed manual and plan on using this as the new heart. ive got an entire donor vehicle with 28000kms on it

ive been reading a few different post on the net about the swap in regards to wiring etc.
What are your thoughts to the painless wiring kit for this conversion? ive played around with diesels but nothing to this extent,

what other things will I need

lift pump setup?

also what diffs come in those rams? my current f250 runs dana 70 rear 60 front

any help would be greatly appreciated

billy

 

Hi Billy I take it your going to use the 6 speed ?
you don't really need that much to get it to run really only 4 wires

where did you get the ram from