Truck died and will not start
#11
replace your UVC gasket, for starts... Is it the gasket or the wire harness?
Once your in there you may as well replace the UVC harness as well. if the one inside seems good, keep it as a spare.
Have someone crank the truck for you, then hook a cheap tire pressure gauge to the shrader valve thats on the side of your fuel pressure regulator. It should be at least 20psi or more. It will be hard to read with the cheap air pressure gauge, but it should give you an idea.
Once your in there you may as well replace the UVC harness as well. if the one inside seems good, keep it as a spare.
Have someone crank the truck for you, then hook a cheap tire pressure gauge to the shrader valve thats on the side of your fuel pressure regulator. It should be at least 20psi or more. It will be hard to read with the cheap air pressure gauge, but it should give you an idea.
#13
Your talking about $300 bucks in parts right there...
#15
---AutoMerged DoublePost---
In this picture you can clearly see where it melted. Would this cause my no start?
Help please this is so frustrating
Thanks everyone
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
bump
Last edited by PSD; 09-24-2010 at 07:37 AM. Reason: Automerged Doublepost
#16
#17
Alright, replaced the UVCH and still nothing...cranks, no start, no smoke, nothing. What should I try now?
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
Found that the wire going to the IPR is completely melted off at the plug. Is this my problem???
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
Just letting everyone know that the problem is solved...
Replaced the connection with one from the old UVCH that i just switched out and the truck started right up.
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
Found that the wire going to the IPR is completely melted off at the plug. Is this my problem???
---AutoMerged DoublePost---
bump
---AutoMerged DoublePost---
Just letting everyone know that the problem is solved...
Replaced the connection with one from the old UVCH that i just switched out and the truck started right up.
Last edited by PSD; 09-28-2010 at 02:46 PM. Reason: Automerged Doublepost