Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   Ford Powerstroke 94-98 7.3L (https://www.dieselbombers.com/ford-powerstroke-94-98-7-3l/)
-   -   96 powerstroke shaking (https://www.dieselbombers.com/ford-powerstroke-94-98-7-3l/37448-96-powerstroke-shaking.html)

atvrider01 12-01-2009 07:06 PM

96 powerstroke shaking
 
i have a 96 powerstroke, and when it is idling in gear and you just barely roll it shakes, also when stoping and barely rolling. it also does it at about 45 mph when its lugging. does anyone have any ideas as to what this could be. it would be greatly apprieciated.

Thanks, Justin

ArizonaRedneck 12-01-2009 10:25 PM

welcome to diesel bombers. i would check drivelineand motor mounts and for play in your diff and your carrier bearing ,u-joints too and good luck hoped i helped if i didnt there will be somebody here that will:rocking:

DieselDanBoy 12-02-2009 07:55 AM


Originally Posted by ArizonaRedneck (Post 443135)
welcome to diesel bombers. i would check drivelineand motor mounts and for play in your diff and your carrier bearing ,u-joints too and good luck hoped i helped if i didnt there will be somebody here that will:rocking:

i would do that ^

and....
check your tranny fluid, smell it to see if it smells burnt, and check the engine oil. i've seen some shaking issues be caused by low or dirty tranny fluid. :c:

atvrider01 12-06-2009 08:28 PM

i asked a diesel mechanic and he told me it could be an injector out.

DieselDanBoy 12-07-2009 07:36 AM

i've also seen that, happened on my buddies truck. i wouldnt call it an injector yet but have someone check the injector harness, could be a burnt wire like in my buddies case. :humm:

atvrider01 12-07-2009 11:51 PM

had that guy run a computer test on injectors. #2 is out and my eot sensor is out. im so excited:argh:

DieselDanBoy 12-08-2009 07:31 AM

thats what i got for my buddies truck too but it turned out to be a burnt wire. make sure he checks the harness. :pca1:

twinboys 12-08-2009 10:27 AM

Try swapping injector #2 with another injector on the same side (#4 would be easiest) and repeat the test. This should tell you if it is the injector or the wiring. Be sure to follow procedure for removing - installing injectors. Check the O-rings while it is out. Be sure to find the correct numbered cylinders, it is not the same order as gassers.


All times are GMT -5. The time now is 05:59 AM.


© 2024 MH Sub I, LLC dba Internet Brands