Truck Won't Start Need Help
my 95 powerstroke will not start the motor just keeps turning over. it is not blowing white smoke like it is cold like it normaly does but is making a weird noise when it turns over like it is trying to pump something. it ran perfectly normal then one night i parked it and didnt plug it in and it wouldnt start. after i plugged it up it quit smoking but wont start. please help if you can... and thanks for your time
|
Must have atleast 100 cranking rpm to activate injectors. Make sure batteries are good and fully charged. When cranking, verify that tachometer is working. This will also tell you if the cps is giving a signal. Check that the wait to start light comes on as it should. If it doesn't, check the maxi fuses in the fuse box in the engine compartment. One of those fuses (30 amp, I think) is required to start and run. It is alo hooked to the lower fuel heater in the fuel filter housing. This heater is notorious for shorting out, blowing the fuse, and causing a no start and a no wait to start light. If this is the case, unplug the lower heater wire (it isn't really needed), replace the fuse and try that. Not sure about the pumping noise.
|
the wait to start light comes on but it stays on longer than normal.. i tried to jump the glow plugs but still nothing. any other solutions out there
|
Any white smoke? Check the oil levels. While someone cranks open the fuel drain valve and make sure the fuel pump is working.
|
the oil levels are good. is the fuel drain valve the switch on front of the pump.? and what is a good way to tell if my pump is working or not?
|
Originally Posted by smokkin2500
(Post 416416)
the oil levels are good. is the fuel drain valve the switch on front of the pump.? and what is a good way to tell if my pump is working or not?
|
All times are GMT -5. The time now is 05:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands