Crank, no start
2006 F250 Powerstoke, AEM cold air intake is the only mod I have on it.
It died on me about a week ago while driving, had it towed to house. Pulled IPR to check the screen and it was clear. I went and bought a Scan Gauge II/X Gauge and got the following results while cranking. Only code I am getting is P0671 (#1 cylinder glow plug circuit) IPR - 84.7 % SYC - 1 ICP - 0 FMP - 49 volts I can't remember what each is suppose to be , but I am assuming that its the ICP that's bad. Any input would be greatly appreciated. |
Bad sensor or high pressure oil leak. Check hpop pressures. If old style, the pumps were questionable. Newer ones develop oil leak in feed to rails
|
Thanks for the reply, the feed to rails you are referring to is that the STC on the HPOP?
|
Yes that's the newer problem. The tubes leak
|
I was wondering if that fixed the problem? Ours has died on twice now while driving and have no clue what's wrong with it.
|
i have seen the windings in the ipr break down under heat this will shut the truck down.when the truck shuts down does it start right back up.:c:
|
No the truck will not start back up. It has been down for a couple of weeks now with no clue as to what could be causing it. We are have to take it in.
|
when it died it started back correct but now it wont.
|
No it never started back up.
|
i sent pm:c:
|
All times are GMT -5. The time now is 07:07 PM. |
© 2024 MH Sub I, LLC dba Internet Brands