Oil leak after EGR delete/oil cooler install
I recently, well, just finished my EGR delete, new oil cooler, coolant filtration kit, blue spring upgrade adn FICM from ED with ATlats tune. I also put my leveling kit on...looks nice!
Sicne i put all the parts in my truck, my truck seems to take a little bit longer to start? It took a few tries before she would start. Once she started running, I noticed the engine would surge or idle up for a brief second. Then I noticed oil leaking on the ground:( I known it's leaking from the turbo oil feed line. I was not sure if there was a gasket there or not. So, I made a gasket to put on the turbo feed line from left over material I had from my old Vette EGR gasket. It did not work, she's spuing out oil from the top of the turbo. I'm tired of working on my truck.....I hurt. 1 Anyway, what could be causing the surge I hear while she's ideling? I have no codes or check engine light on. 2 Prolonged start causes? 3 And do I need a gasket for the oil feed line to the top of the turbo? thanks for the help, I"m gonna have another beer and go to bed:humm: ---AutoMerged DoublePost--- Well, scratch the bed and beer. I went out and took the oil feed line off and found the new gasket I made and the old one. I was not sure if the feed line had a gasket or not....guess it does. I put the old gasket on and it seemed like it was in good condition. I sealed up the two bolts with gasket in place...it's still leaking, just not as bad. Man, I hope I did not bust the oil feed line...that would be my luck. Any thougths on this? |
You need a new gasket. Also, if you have the old flexible steel braided turbo feed line you can get new updated hard line with gaskets and o ring. The hard start and maybe even the surge should clear up after you put some miles on the truck and get all the air worked out of the system.
|
Surge is gone. I drove her around the block and the surge is gone, now.....time to fix the leak:argh:
I am out of "car shape" ---AutoMerged DoublePost--- That little gasket did the trick! The old gasket looked fine, but definalty didn't work. Glad to be done with this project! GLAD! Now I can enjoy her. |
All times are GMT -5. The time now is 08:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands