Crap quality bolts tick me off!
So, I have 6 brand new high lift two tone jack stands. I start putting them together and the first thing I notice is that there are no instructions. None at all. I can figure this stuff out, but a bit of effort on the manufacturers part is expected. So, I figure out where everything goes before starting the assembly process, and using hand tools and no excessive force I promptly twist the head off of one bolt, and strip the threads off of two other bolts!
At this point I get on the old interweb and look up what "4.8" stamped on the end of a metric bolt means. Come to find out it is LOWER than grade 2 standard bolt specifications! :argh::argh::argh: Anything I put together is Grade 5 or Grade 8 (metric equivalents are 8.8 for grade 5 and 10.9 for grade 8). I figure it is going to cost me around $15 each for new grade 8 hardware. If I am trusting this stuff to keep a truck off of me I can afford an extra $90. My biggest beef is the delay in assembling them is a pain in the ass. Later, Keith |
Most time's low grade bolts are more than enough for the job they're tasked with and everyone tends to use a higher strength bolt unnecessarliy. With that said... hardware is cheap enough that usually no one concerns themselves with what is right or wrong and just over shoots. Not a bad thing. I'm a mechanical engineer by trade and had to spec out bolts for some projects before and people give you strange looks when you tell them a grade 2 bolt will work just fine. They're usually amazed when you can prove it with math too.
Regardless, the head still shouldn't have spun off. I wonder if the bolts weren't heat treated properly. |
Can we say MADE IN CHINA????????????
|
Originally Posted by Mdub707
(Post 979259)
Most time's low grade bolts are more than enough for the job they're tasked with and everyone tends to use a higher strength bolt unnecessarliy. With that said... hardware is cheap enough that usually no one concerns themselves with what is right or wrong and just over shoots. Not a bad thing. I'm a mechanical engineer by trade and had to spec out bolts for some projects before and people give you strange looks when you tell them a grade 2 bolt will work just fine. They're usually amazed when you can prove it with math too.
Regardless, the head still shouldn't have spun off. I wonder if the bolts weren't heat treated properly. Later, Keith |
I had a EMD turbo instructor inform me about the meaning of "china" made parts. It stands for Can Hold Infinite Number or Amount. Haha!! Also if its over my head, I aint gonna let a China part hold it.
|
All times are GMT -5. The time now is 07:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands