P132B?
I'm haveing this code keep poping up own my programmer. I have replaced the right side y pipe checked for leaks. cleaned the egr valve to make sure it wasn't sticking and the mfs sensor and air filter. I'm running a cold air intake a edge evolution programmer with the stock exhaust except with the cat deleted any ideas would be greatly appreciated. I also had the turbo vanes cleaned to make sure they wasn't sticking
|
It's usually a turbo issue.
Check this out: Code P132B and turbo noise - PowerStrokeNation : Ford Powerstroke Diesel Forum |
thanks for the reply mdub707 I will double check the turbo when i nail the throttle my boost gauge will only go to 21 psi should it be getting hight than that
|
Usually 22-24 is about right, might be a hair low. Maybe you have a leak on the up-pipes?
|
If I was getting low fuel pressure would that lower my turbo pressure
|
Absolutely. No fuel to burn means no heat, which drives the turbo... however I doubt that's your issue, if you had low fuel pressure you'd know it. It would also be destroying your injectors.
I have seen cases before where just simply having an aftermarket intake will cause the code. Do you have the stock box kicking around just to try? |
changed the mfs now have no codes showing up and is getting up to 25 psi boost. hopefully nothing else will go wrong thanks for the help
|
MFS?
Glad you got it fixed! |
All times are GMT -5. The time now is 10:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands