that looks sweet man!
|
Thanks!:c:
|
Amber is pulling with it...
Originally Posted by BBRam
(Post 33024)
Where is the Truck? :pc:
---AutoMerged DoublePost--- I'll take one of each Ian, those look sweet!!! one thing I'm sure you've thought about but thought I'd bring up anyway... On the driveshaft loop, make sure it fits tight enough it doesnt rattle going down the road with the quick pin design. Again, I'm sure you already thought of it, but could not stop myself!!!:tttt: If I could weld aluminum I would make my own rad. cover |
Originally Posted by Bosshogg
(Post 61160)
Amber is pulling with it...
---AutoMerged DoublePost--- I'll take one of each Ian, those look sweet!!! one thing I'm sure you've thought about but thought I'd bring up anyway... On the driveshaft loop, make sure it fits tight enough it doesnt rattle going down the road with the quick pin design. Again, I'm sure you already thought of it, but could not stop myself!!!:tttt: If I could weld aluminum I would make my own rad. cover Amber did make her first pass down the track with 271' at the New Era pull in Zanesville. I rode shotgun and it was stressful! but Im very proud of her, the truck did start to dig a bit at the end and she freaked out and let off the go pedal. The loop doesnt make any noise. the pin is up high enough that there isnt much wiggle and I also put never-seize on it to keep it free. Ian |
Ian, you can consider your ideas as good as stolen, thanks bud.
|
Originally Posted by cashwheel
(Post 61605)
Ian, you can consider your ideas as good as stolen, thanks bud.
if ya need specs on either of them let me know Ian |
All times are GMT -5. The time now is 12:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands