OIL Fill Cap / Breather Vent Mod
4 Attachment(s)
If you are running high boost and crank case pressure this is a good mod for you!
parts list Dremel Gorilla glue Oil cap- Napa P/N: 703-1458 Breather Filter- Auto Zone P/N: 3998 Brand "Spectre" clamp the cap in a vise with a rag or small towel (not too much or you'll break it) then drill a hole about 3/4" or what looks to be large enough for the rubber tube from the breather will fit in BUT not to big where it will be loose. I used a Dremel side Drill and then a deburring tool to finish up the hole. then put some glue on the rubber part of the filter as well as the oil cap. push in and youre done! Note- test fit all your parts prior to glue! AND my filter was a little loose from the rubber gromet that was supplied so I glued that as well to keep it from vibrating while the motor is running a couple pics: Attachment 59728 Attachment 59729 Attachment 59730 LAmiller's truck from CompD.com: Attachment 59731 Ian |
Very nice job. :up:
|
nice mod :U:
|
Thanks guys
Ill let ya know how it goes once I get the rig back!! :choochoo: |
Damn, one more idea to steal from you. If you keep putting this stuff on the site our trucks are going to be identical.:c:
|
Originally Posted by cashwheel
(Post 73833)
Damn, one more idea to steal from you. If you keep putting this stuff on the site our trucks are going to be identical.:c:
|
whats the best way to do this on a 12v
|
Big Bad Dodge did it!
here is the link for the 12V scroll all the way down to almost the bottom and you'll see: http://www.bigbaddodge.com/Motor.html |
good
LOOKS good !!!!!
|
All times are GMT -5. The time now is 03:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands