Kubota V2203 Torque spec for oil pan
 

good evening I am putting the new to me stamped steel oil pan on the Kubota V2203. Does anyone have the torque spec from Bobcat? The bolts are M10-1.25 grade 4. from the Carrier manual I get 33ft/lbs, does that sound correct.

That's probably about right, My book is in the garage, it'll be tomorrow before I can look it up.

thanks later tonight I will be drilling the block for oil dipstick, and a turbo oil return. I don't think I will be torqueing tonight
who had the pics and bit size for the dipstick? I have not figured out the size for the turbo oil return yet. I am thinking 1/4, or 3/8" pipe

I have the drill bit size for the Bobcat 743 dip stick, but again it's in the garage, sorry. I'll get it for you tomorrow. Where are drilling the oil return for the turbo?

I am planning on putting the dipstick on the passenger side fwd just under the injector pump, on the slightly angled sort of round part. The turbo drain will go in the same place on the drivers side.
I will try and take a pick after dinner