|
Originally Posted by rolloffhill
(Post 26735)
If you have any questions as to what trouble code you are having with your Duramax, post the code here and we will be glad to let you know what it is and help you decide what can be done to fix it if applicable. :)
|
Originally Posted by sweeneypf
(Post 826256)
P1713 code... 2001 GMC Sierra 2500HD 6.6 Allison
Modules: Description: Transmission Reverse Pressure Switch Circuit Malfunction |
P1713 code Duramax
ThanX BriteWhiteRam I appreciate your posting of code translation.. It is a start ad can now consult GMC to see if it's major or minor. Like to know ahead of time before saying there's a code, check and let me know. They can say anything if you don't know the code before hand. ThanX again!:jump:
|
jimk
Originally Posted by rolloffhill
(Post 26735)
If you have any questions as to what trouble code you are having with your Duramax, post the code here and we will be glad to let you know what it is and help you decide what can be done to fix it if applicable. :)
|
error code p2149
Any idea what this code indicates? Thank you!
Also have seen codes P0202, P0203, P0205, and P0208... I know they have something to do with the cylinders.. but not sure what or what fix. |
0687, I know its high ECU voltage? Any hints on where to start to figure out why its getting high voltage? The alternator is putting out right at 14.
ads |
I also checked the ECM relay and its fine
|
Trouble code p0700
When the transmission downshifts from overdrive to 4th it sets a po700. It is when I'm
pulling my fifth wheel only. I have to pull over and turn the power off to get the tranny out of limb mode. Any suggestions will be greatly appreciated. |
ECM U1096
:s:I have a 2006 lbz with efi live, air dog, ats trans, with my efi live if I am on a low tune under 80 horse no problems, as soon as I go to smoke, econ, or power if I hammer on it it starts bogging down until I let off and idles like crap for a few seconds and throws the code ecm u1096. I can clear it and it stays away but if I hit it again it comes back. if I am on a lower tune and hit it it functions properly?
---AutoMerged DoublePost---
Originally Posted by jlesko
(Post 1057750)
:s:I have a 2006 lbz with efi live, air dog, ats trans, with my efi live if I am on a low tune under 80 horse no problems, as soon as I go to smoke, econ, or power if I hammer on it it starts bogging down until I let off and idles like crap for a few seconds and throws the code ecm u1096. I can clear it and it stays away but if I hit it again it comes back. if I am on a lower tune and hit it it functions properly?
but 90 percent of the time when it bogs and trips a code it is the u1096 |
code 1082?
Originally Posted by rolloffhill
(Post 26735)
If you have any questions as to what trouble code you are having with your Duramax, post the code here and we will be glad to let you know what it is and help you decide what can be done to fix it if applicable. :)
|
| All times are GMT -5. The time now is 04:42 AM. |
© 2024 MH Sub I, LLC dba Internet Brands