Limp mode after trans go jr
Hey im new here sorry if I don't put this in the right place but I have a 06 3500 lbz with 226,xxx 4 inch turbo back and edge evolution running on level 3 it threw p0700 and p0777 went to fourth let it set a day started it had all gears drove it for a week pulled it in the shop to change the fluid,filters and put in a transgo found no shavings like if it would have slipped the clutches got the transgo in have had the pan off several times and changed to another valve body worked for a half a mile shifted 1-2 went inside left idling for 5 minutes then went from first to fourth. New internal wiring harness no change new tcm no change new ims new change went back to original valve body now have 3rd and reverse along with p0700 p0972 and p0975. Bout ready to build it just wanted to see if anyone has had this happen before.
|
Check to make sure the solenoids are not mixed up an all of the connectors are seated properly
|
Found the problem
Originally Posted by 2004LB7
(Post 1097418)
Check to make sure the solenoids are not mixed up an all of the connectors are seated properly
|
Hey
So did you take it to a shop for them to tell you about the Solenoids sticking or did you check valve body yourself? I’m having the same issue I just replaced the pass through seal the one that’s not suppose to have tranny fluid in and put new tranny fluid in but still pulls the 2671 code for high voltage
|
All times are GMT -5. The time now is 04:48 AM. |
© 2024 MH Sub I, LLC dba Internet Brands