6.2 with a sm465 4 speed transmission?
Hey im switching transmissions in my 86 k35 and need to know if a sm465 transmission (out of a k20) will fit on a 6.2? Also i need to know if a np208 (4wd transfercase out of a k35) will go on the 4 speed transmission?
|
i dont know and if no one answers you here i would join a offroad truck forum and ask them. the type of people that are into swapping t-cases and trannys all the time. there the people to ask
|
i am not very furmiliar with the 6.2s but i was told that they were made with the chevy 350 block if that is the case then the sm465 will bolt up to it. i think the only difference might be the flywheel and clutch size if anything and mabye the pilot bearing hole might be different in the crankshaft. as far as the t case goes i would say that you will probably have to get another transmission to t case adapter and it should work. those are just a few things i would check before spending too much time and money on it.
|
I'll ask on an offroad site but i think your right cfarley, i have the two trucks so i mind as well try couldnt hurt. Thanks
|
Originally Posted by cfarley0210
(Post 501519)
i am not very furmiliar with the 6.2s but i was told that they were made with the chevy 350 block if that is the case then the sm465 will bolt up to it.
The 6.2 comes over to about a 373 ci. So it'll be a big block like the 454. On the transmission, if it came out of a 4x4, it'll work. If not, your going to need a longer output shaft. |
well the transmission is out of a 2wd truck, the engine and the transfer case is out of a 4wd truck. So will the engine a transmission fit and will the transfer case fit on the transmission, or just one or the other? I'd rather have the adapters i need (if I need any) before i start tearing into this project and get stuck waitingfor a hard to find adapter to come.:argh:
|
the tranny output shaft most likely wont work for a 4x4. depending on what the t case is out of you might need a different adapter to the tranny. if it is a chevy bb it will mount up. i am just not sure about the clutch and pilot bearing but most likely it should work. it sounds like your getting into a big head ache of a project. im not trying to discourage you but i have had projects like that and it seems like everything goes wrong and they are just a pain.
|
ya, been there done that also but i really want to put the 4 speed in the truck, and get ride of the th400 b/c it slips terrible.
|
adapter
call advance adapter for the parts needed to mate what u want they have everthing, did my truck with their adapters.Swap experts
---AutoMerged DoublePost--- also if money is not to tight you can order an atlas transfer case to fit your application and dump that chain drive case. |
sm 465 to a np205 are not hard to find i even have one for sale but i do know for a gasser that a small block bell housing and a big block bell housing are the same i have heard that the bell housings are the same on a 6.2 to a gasser but i have never done the swap my self but if i were u i would just go with the 4x4 trans mission and not deal with the the sm465 are not really fun to take apart
|
All times are GMT -5. The time now is 12:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands