electronic to mecahnical injection
 

I was wanting to switch a 95 6.5 TD over to mechanical injection since the engine will be dropped into a 1993 truck. It has a manual transmission so no worries there but i dont know what else is needed. Can i just put my injection pump of the 93 on the 95 engine and change the lines or is there more that needs to be done? Any help would be appreciated

so if i understand you corretly your just putting the pump and the lines from the 93 on the 95. if so then your good to go. nothing else needed. just going to have a bunch of senors with nothing to plug into

ok. Thanks. The emty sensors shouldnt affect anything though if i am thinking correctly. If i'm wrong please correct me. Ive got all the parts to the the 93 engine but the block was broke where the starter mounts to it and it couldnt be fixed. And i bought the truck thinking i could fix it but it was destroyed. I was going to find another block and do a rebuild but the kit is so expensive, i'm trying to find an alternative method and i found a running 95 6.5 for very cheap. If you have any other solutions, i'm all ears.

sensors will just look kinda wierd. i would zip tie them together. what your doing sounds good just hope the 95 has a good engine

i just talked to someone a couple days ago that did this and he didn't have any problems. basically use the long block out of the newer motor.

thanks guys for the response and advice, havent been on here very long but seems like a very good community of people. Thanks again.:tu:

your welcome:tu: