Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   Chevy/GMC 6.2L and 6.5L (https://www.dieselbombers.com/chevy-gmc-6-2l-6-5l/)
-   -   Idles OK but stalls when rpms drop fast. (https://www.dieselbombers.com/chevy-gmc-6-2l-6-5l/115950-idles-ok-but-stalls-when-rpms-drop-fast.html)

rebar 10-11-2013 04:12 PM

Idles OK but stalls when rpms drop fast.
 
Iv never had any issues with my 1991 NA 6.2 But I let the wife run it, and I'm sure she forgot to add power service additive once or twice. I go to drive it, and it die's at the first stop sign. It idles OK. But if I'm running in gear and push the clutch in to stop. It drops rpm fast enough to kill the engine most of the time. I changed the fuel filter behind my intake which helped my overall power, but it still wants to die when I drop the rpm fast.
Iv learned to leave the clutch alone until the rpm's are low when stopping, then push clutch in and it stay's running.. But I'm worried something is starting to fail..

I just blew up my cummins, so I dont need another car down.

Any suggestions what to check? Or have checked? Thanks!

racer55 10-11-2013 06:37 PM

Mechanical lift pump working?

rebar 10-11-2013 08:49 PM


Originally Posted by racer55 (Post 1029809)
Mechanical lift pump working?

Guess that's the first place I should look. If it fails, can it hurt the injection pump?

This truck has about 120k with nothing but routine maintenance.

racer55 10-12-2013 06:44 AM

It will make the IP wear out faster if there is no supply/lift pump.

rebar 10-20-2013 10:12 AM


Originally Posted by racer55 (Post 1029877)
It will make the IP wear out faster if there is no supply/lift pump.

I replaced the filter and it runs great again..

The only problem is, I have a leak now. I put my hand under the filter and it was wet with fuel and ending up under the truck.

How did I screw that up? I did have to push pretty hard to get the last bottom wire clip snapped in position, but my only option now is to replace it again unless someone has another suggestion.

racer55 10-20-2013 11:56 AM

Oring get cut on the air bleed?

rebar 10-20-2013 12:01 PM


Originally Posted by racer55 (Post 1031190)
Oring get cut on the air bleed?

Well, fuel isn't coming out of the air bleed tube, so I don't think so.

racer55 10-20-2013 12:13 PM

Round filter in a housing or square filter on a plate?

Sometimes it is just a defective filter?

rebar 10-20-2013 12:17 PM


Originally Posted by racer55 (Post 1031195)
Round filter in a housing or square filter on a plate?

Sometimes it is just a defective filter?

Square filter on the back of the intake..

Yea, I talked to Orielly and they said I could return the wix for a new one. Is the Microgard better?

racer55 10-20-2013 12:30 PM

I have good luck with wix but anything can be bad.


All times are GMT -5. The time now is 06:22 PM.


© 2024 MH Sub I, LLC dba Internet Brands