How To Level Tow Mirrors On A GMC
Information posted by reyb.
1. Remove the plastic cover that is covering up the hinge part. Be careful because that piece of plastic has a sharp edge; I cut myself the first time I pulled it off. 2. Inside you'll see 4 phillip screws that is holding down the hinge; remove these and let the mirror hang down. 3. Take the hinge clamp off from the mirror post. The clamp is what the phillips screws go through and the mirror post is what the clamp goes around. 4. Cut each side of the hinge clamp right in the middle. 5. Bend the top of the hinge clamp at the screw hole inward such that at the cut it is bent outwards the same thickness of the metal itself. 6. Bend the bottom of the hinge clamp at the screw hold inward as well such that at the cut it is bent inwards the same thickness of the metal. Note: Steps 5 and 6 may be confusing but visualize what you are trying to do and it'll make sense. The reason for making these bend is such that the mounting surface where the clamp meets the mount base is square. 7. Insert 3 washers between the top of the hinge clamp and the mount base and get some longer screws in which to secure the clamp. The washers about the thickness of a penny. The new screws on top were about 15mm in length. 8 Trim the plastic cover a bit where you see it rubbing. |
ive heard that if you use two washers instead of 3 you wont need longer screws and it levels out pretty fine too
|
well i should be doing this in the next week or so my second mirror should be in on wed
|
All times are GMT -5. The time now is 11:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands