2wd to 4wd
What do you have to do to swap a 4l60e trans out a chevy van to a 4wd truck? Do oyu just have to change the tail shaft?
|
i cant remember if the tail shaft is removeable, you might need ahold new transmission housing.
|
cause the tranny in the suburban is out and we found a 15 passenger van with the same tranny but were not sure about hooking up the transfer case
|
swap the rear output shaft and housing.....
|
The rear out out put housing should have a set of bolts holding the 2wd flange to the rear of the tranns. I think it would only be four bolts to change the flange and shaft out. At least this is what it was like on the early to mid 80's blazers.
|
i just looked at one, remove the tail housing and output shaft as stated above
|
Sweet thanks guys
|
Quite welcome.:U:
|
not a bad job
|
All times are GMT -5. The time now is 07:47 PM. |
© 2024 MH Sub I, LLC dba Internet Brands