international 4700 t444e NO START
#1
international 4700 t444e NO START
ok im having a hard time here. i have a 96 international 4700 rollback with the navistar t444e engine. my father said it died then started and ran, then died and wouldnt run. i have been dickin with it and cant figure it out. it has crystal clean fuel, new fuel filter, cleaned the pre-filter screen, new cam sensor, and i tried an idm out of an f-350. it cranks nice and fast and has 40 to 50 psi of fuel pressure. i pulled the icp sensor out and turned it over and it is pumping oil, im just not sure how to test how much, or how to test if the sensor is working. also, any idea how to test if the idm is geting power or of the injectors are getting any kind of signal? i dont see any smoke of any color while cranking. im baffled. any input would be great. thanks
#4
We a have a fleet of these at work and its a regular problem. We have a scan tool to read icp but if you don't this method works too.
When cranking you should hear the injectors making a clicking noise. If you don't hear them you more than likely have a stuck ipr or oil got the best of the wires going to it and it needs those wire replaced. IHC sells a kit if thats the case
When cranking you should hear the injectors making a clicking noise. If you don't hear them you more than likely have a stuck ipr or oil got the best of the wires going to it and it needs those wire replaced. IHC sells a kit if thats the case
#6
whats ipr? and how do i know it has oil pressure for sure? i think i might just throw an icp sensor in it just to eliminate that. i thought about the oil getting the best of the wires and it seems a lil unlikely that it would happen to both sides. i am almost positive the injectors do not click.
#7
The ipr (injector pressure regulator) is a little valve that controls the pressure going to the oil rails in the cylinder heads. It resides down in the valley towards the front of the engine. Over time it tends to get clogged up with debris and can get stuck closed causing low power or no start conditions. I would replace the ipr and icp and it should start,worst case senario it could need a hpop.
Heres a site that kinda show what im rambling about.
http://www.fordtechservice.dealercon...iagnostics.pdf
Heres a site that kinda show what im rambling about.
http://www.fordtechservice.dealercon...iagnostics.pdf
#9
#10
Thread
Thread Starter
Forum
Replies
Last Post
cjgregory
Diesel In Distress - Support Ticket
0
03-31-2015 01:45 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
carid
Diesel Bombers Sponsors
0
11-18-2014 06:49 AM
ayvahaiden
Ford Powerstroke 94-98 7.3L
3
11-03-2014 07:30 AM