In-cab Inverter mount, with outlets!
 

So, I'm new, but I wanted to show off my inverter install and outlets.
Other people have done outlets like this, but I like mine. :)
Inverter: 1200w Peak brand, with remote on/off switch, usb's and 120v outlets
Attachment 35083
Mounted remote box in lower dash cubby:(PITA!)
Attachment 35084
Put Outlets in the B-pillars, used the driver side one to tie more wire in to reach from the remote box, back to the inverter:
Attachment 35085
Attachment 35086
The passenger side one is mounted higher, because the molding is actually flat, so the cover plate fits good. Didn't think about that detail on the driver side until after I already had wires cut, Oh well...
I don't have pics, but the inverter is mounted under the little flap at the very back of the cab, so no interference with the seat folding up/down, and no loss of storage space!

hey as an electrician:tu: did you have a permit and inspection? cool

Of course!:nope:

Wow even Tamper Resistant decora outlets! Only thing is that's a square wave inverter but it might not be an issue depending on your application.

That is cool, why would square wave be a problem?

They were the cheapest black square outlets! I'll test the few things I'll be using it for when I actually get it wired in, but I'm not terribly concerned. It was cheap, and I'm sure it will be fine for my laptops, and phone chargers.

Here's some pics of where it is mounted.
Attachment 35051
Underside, showing bolts:
Attachment 35052
Test fit.
Attachment 35053
Nice and snug, I'll have to monitor temps on it when it runs.
Attachment 35054

It's not actually wired up yet, still saving money for the the $100 of cable I need to move my batterys to under the bed. But it will be awesome when it's done! lol