Hi new to forum done some research and im looking to build a 2.6 puller that will be competitive. I'm stuck on which injection I want to go with (p-pump or cr) and I know with the cr i need to do a motor swap. Looking at a 66-74-14 with a billit wheel and dual disc clutch and dana 80 duals out back. Any info insight or help would be great thanks in advance

 

with a built p pump, you will get more fueling capabilites than out of a CP3 any day, and p pump swap is cheaper than buying a CR motor,

 

I was thinking a good 13mm p-pump but dual cp3 would be fun