Autometer 5760 installation ?
 

I got an Autometer fuel pressure gauage 5760.

Where is the best place to connect the sensor to? The fuel filter has no place to connect to!

Thanks for information in advance.

MR

Does it use a banjo bolt?

i used a brass t with the same sized barbed fitting as your fuel fine is. then find bushings to make the top of the t go down to the sensor size. i think it cost me ten bucks or so to install it

I figured it out.
Got an adaptor for the right side of the fuel filter with the banjo bolt. The area is a little too tight for these old hands; and bifocals glasses did not help either.
But made it in there and now I have fuel pressure gauge.
Too bad I got it done before reading about the T connection. That would have been less painful. Thanks