Down Pipe
What's the best way to pull a down pipe off of a 6.7L cummins. I'm going to put a 5" staright pipe on mine.
|
remove the trans mount bolts, jack up the trans, loosen and remove the cross member bolts, you can leave one in the drivers side, and just swing the cross member down on the passenger side.
Remove bolts from the pipe support, and the v band clamp where the pipe bolts to the back of the turbo |
^^^^^ what he said!! Was the hardest part of my whole delete process!
|
about 5 mins and a torch a saw is ok but better have a lot of blades that stuff is tuff right there its not your normal exhaust pipe:tu:
|
yup, and then when our wonderful EPA makes us put 'em back on, you gotta buy one.
No thanks |
so dont deal with the epa. know your ways around it or leave it stock. theres ways around everything. my truck will never run emissions again. worst come to worse my truck will wind up being an 07 5.9 on the title and vin numbers anyway.
|
good for you
|
Still have to move that cross piece so u can get the new one in. Or i did at least!
|
AFE used to make a two piece downpipe, not sure if they still do.
You could get that one in if you wanted to cut your original out |
my 5'' went right in no problems.
|
All times are GMT -5. The time now is 02:20 AM. |
© 2024 MH Sub I, LLC dba Internet Brands